Roper RAB2121P Washing Machine Operation Manual

The Roper RAB2121P is a compact top-loading automatic washing machine ideal for small spaces and light loads. It features simple controls for water levels and temperatures, with cycles including Regular, Delicate, and Rinse/Spin. This manual provides key specifications, operation instructions, and installation guidance for optimal performance.

Key Specifications

• Type: Compact top-loading automatic washing machine
• Compatibility:
  • Suitable for light loads of cottons, delicates, and everyday fabrics
  • Not recommended for bulky items or flammable solvents
• Power Source:
  • Electrical: 120 V AC, 60 Hz, 15 A circuit
  • Water Supply: Hot and cold faucets within 4 ft (1.2 m)
• Electrical Rating:
  • Motor: 1/4 HP single speed
  • Wash Speeds: Standard agitation/spin
  • Water Levels: Mini, small, medium (selectable)
  • Temperature Settings: Hot, warm, cold
• Capacity: 1.9 cu. ft. (tub volume)
• Dimensions: 23" W x 36" H x 22" D (58.4 cm x 91.4 cm x 55.9 cm)
• Features:
  • Manual lint filter
  • Bleach dispenser
  • Simple cycle knob
  • End-of-cycle signal
  • Agitator for effective cleaning
• Operating Conditions:
  • Temperature: 34°F to 110°F (1°C to 43°C)
  • Humidity: Non-condensing
• Cycles:
  • Regular: For everyday loads
  • Delicate: Gentle for fine fabrics
  • Rinse/Spin: Additional rinse and spin

Operation Instructions

Initial Setup

1. Check Components: Confirm hoses and manual are present. Read instructions fully.
2. Power On: Plug into grounded outlet; open water faucets.
3. Configure Settings:

• Select medium water level and warm temperature for test.
• Clean lint filter by removing and rinsing.

4. Test Run: Run empty Regular cycle to verify function and check leaks.

Operating the Washing Machine

1. Sort Laundry: By color, soil, and fabric. See Laundry Tips.
2. Add Detergent: Measure and place in basket before clothes.
3. Load Clothes: Loosely up to water level mark.
4. Select Settings: Cycle, water level, temperature. Close lid.
5. Start Cycle: Turn knob to start. Machine fills, washes, rinses, spins. Stop by turning to Off.
6. End Cycle: Remove items immediately.

Cycle Selection

Choose based on load type:

• Regular: Cottons, linens; 8-12 min wash; hot/warm/cold.
• Delicate: Silks, lingerie; gentle, 6 min wash; warm/cold.
• Rinse/Spin: Extra rinse; cold water, high spin.

Note: Adjust time if needed on Regular.

Laundry Tips

• Sorting: Whites from colors; heavy from light.
• Stains: Pre-treat promptly.
• Detergent: Use correct amount for load size.
• Bleach: Add to dispenser; color-safe only.
• Load: Avoid overloading for best results.
• Temperature: Hot for soils, cold for energy save.
• Filter: Clean after each use.

Troubleshooting

• No Power: Check outlet, cord; reset breaker.
• No Water: Faucets on? Hoses clear?
• Leaks: Tighten connections; level unit.
• Vibration: Level feet; balance load.
• Poor Drain: Check hose; clean filter.
• Short Cycles: Low water level; adjust setting.
• Odors: Run hot empty cycle with bleach.

Installation Instructions

Warning: Disconnect power/water before install. Ground properly.

Remove Old Washing Machine

• Shut off water/unplug.
• Detach hoses/drain.
• Remove shipping if needed.
• Clean area.

Installing New Washing Machine

1. Unpack/remove materials.
2. Position with clearance.
3. Connect hoses: hot/cold.
4. Attach drain hose (24-72" height).
5. Level machine.
6. Test connections.

Leveling the Machine

• Level on top.
• Adjust feet evenly.
• Tighten nuts.
• Recheck post-run.

Electrical and Water Connections

15 A outlet. Water 20-100 psi.

Connection Type	Description
Electrical	Grounded 3-prong; no extensions
Hot Inlet	Hot faucet; 110°F max
Cold Inlet	Cold faucet; 20-100 psi
Drain	Standpipe; secure

Caution: Check leaks.